How to Install a Drain Pump For a Basement

The best under sink drain pump for your basement sinks can be found by following a few simple steps. Most of the time the problem is that people don’t follow the proper procedure when they are trying to replace or repair their drains. Most often people will try to cut cost by doing the job themselves and end up with an unusable machine. Before I go any further, you need to make sure you have the correct measurements in place for your sink’s drain hole. If you do not then you will not get the best result from your investment.

How to Install a Drain Pump For a Basement

The first step involves getting your measuring tape and marking the exact size of your sink hole. You should also measure the pipe from the pipe line going to the sewer to where your pipes are located. This will give you an idea of how deep your pipe will have to go. This is necessary so that you can buy the right pipe length and auger the drain pipe properly.

The next step is to remove the sink and prepare the area for installation.

If you have a drain opening in your basement then it is best to remove the whole thing for this procedure. Unhook the water supply pipe from its valve and you will then need to locate the drain pipe for it. This can be done with a wrench or crescent wrench.

Some people prefer to set up dual pipes that will be attached to each other.

If you do this, make sure that you read all of the instructions before you do it. Otherwise you may damage the pipe that is attached to your old sink. Some homeowners like to do both types of installations so that they have the best under sink pump for a basement. It is important to know how to choose the best under sink pump for your basement to ensure that it functions properly.

Once you have located your new sink, measure the depth of the sink.

Then you will need to purchase the pipe length needed. This measurement will determine how deep your sink will be able to go to. A common problem with some homeowners is that their sinks may only be deep enough to allow the water to drain correctly but not deep enough to be able to completely drain the water out of the sink. For this you will want the pipe that goes to your drain to be at least three times as long as the depth of your sink.

Once you have bought the pipe, you will need to run it through your drain and attach it to the fitting on top of your sink.

Once this is complete you will be ready to attach the bottom of the pump to the pipe that attaches to your drain. Most fittings are made of galvanized steel. If you choose to use plastic or other materials, you will want to make sure that the fitting is specifically designed for the material so as not to cause damage.

One of the best ways to ensure that your basement has the best possible water pressure is by using a high quality water pump.

These are typically only about thirty-five dollars and can save you a lot of money in the long run. One of the best parts of these pumps is that they have automatic shut off capabilities.

If you are learning how to install a drain pump for a basement, you are going to find that there are many benefits to making sure that you have the best equipment available on the market.

These pumps are great for reducing water loss and can save you a lot of money over time. You should also make sure that you learn how to read the gauge to ensure that you are purchasing the right size pump for your needs. It may take a little bit of work but you will be glad that you took the time to do it correctly the first time around.

We will be happy to hear your thoughts

Leave a reply

Home Sweet Home
Logo
Enable registration in settings - general